![]() Set the IP address of the controller preferably to 169.254.5.182 which is an IP address in the same subnet as the Pickit IP and set the subnet mask to 255.255.0.0. Open RobotStudio and follow the next steps: This Ethernet cable should be plugged in: The Pickit processor has to be connected to the robot controller using Setup the network connection Hardware connection If you don’t have the right software version or module please contact To check this compatibility, open RobotStudio and follow the next steps: To communicate with Pickit, the following controller modules need to be installed: Pickit is compatible with controllers as of version IRC5 with RobotWare 5 or 6 and furthermore. Check controller and software compatibilityĬheck controller and software compatibility
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |